EPever 50A MPPT Solar Charge Controller Tracer5415AN

Write a review
Ask a question
Tracer 5415AN
In stock
Please Pay Attention To The Voltage
EPever 50A 200V MPPT Solar Charge Controller

PowMr UK warehouse,AUS warehouse,USA warehouse,GER warehouse and China warehouse

BrandEPever Lithium Battery Activation Active Lithium Batteries Battery Voltage12V, 24V Battery TypeLifepo4 Batteries, Lithium Batteries, Flooded Batteries, Gel Batteries, Lead-acid Batteries, AGM Batteries, User Mode Solar Panel Max Input Voltage150V Solar Panel Max Input Power1040W-2500W Ground TypeNetagive Ground Charging Current50 Amps WarehouseUSA Warehouse, GER Warehouse
$19999
+

Minimum quantity for "EPever 50A MPPT Solar Charge Controller Tracer5415AN" is 1.

Why PowMr?
  • — 24 months warranty
  • — Fast Delivery
  • — 8 hours service 
  • PowMr Everywhere 

Wholesale

EPever 50A MPPT Solar Charge Controller 12V 24V 36V 48V Auto Solar Regulator with LCD Display 150v 200v Tracer5415AN Tracer5420AN

Features:

  • Brand: Powmr
  • Product Model: Tracer 5415AN
  • CE certfication(LVD EN/IEC62109,EMC EN61000-6-1/3)High quality & low failure rate components of ST and Infineon to ensure the product’s life
  • Advanced MPPT technology & ultra-fast tracking speed is up to 99.5% guaranteed
  • Maximum DC/DC transfer efficiency is as high as 98.7%
  • Advanced MPPT control algorithm will minimize the MPP loss rate and loss time
  • The accuracy of the recognition and tracking at the highest point of multiple-peaks MPP
  • The wider range of MPP operating voltage
  • Auto control system to limit the charging power & current go over the rated value
  • Support 4 charging options: Sealed, Gel, Flooded and User
  • Battery temperature compensation function
  • Real-time energy recording and statistical function
  • Automatic over-temperature power reduction function
  • Hundred percent full load operation in working environment temperature range within charging & discharging
  • Support up to 8 units in parallel to expand system
  • Load relay control external load switch signal to realize diversified load work modes
  • The first and the second disconnection of load control, contain two relay’s contact
  • Auto-control of utility and generator relay design
  • Utility or generator auto-control relays make it easy to compose the hybrid power system
  • The remote temperature and the voltage sensor design will collect accurate data of battery temperature and voltage
  • Isolated RS-485 with 5VDC/200mA to protect output for no power devices with MODBUS protocol
  • To monitor or set the parameters by using the phone Apps or PC software


Electronic protections:

  • PV over current/power protection
  • PV short circuit protection
  • PV reverse polarity protection
  • Night reverse charging protection
  • Battery over voltage protection
  • Battery over discharge protection
  • Battery over heating protection
  • Controller over heating protection
  • TVS high voltage transients protection


Specification:

Rated charge current: 50A

Rated discharge current: 50A

Battery input voltage range: 8-68V

Max. PV open circuit voltage: 150V

Rated charge power: 625W(12V);1250W(24V);1875W(36V);2500W(48V)

Self-consumption: 98mA/12V;60mA/24V;50mA/36V;46mA/48V

Temperature compensate coefficient: -3mV/ /2V(Default)

Dimension: 261×216×119mm

Power terminals: 6AWG(16mm²)

Net weight: 3.5kg

Enclosure: IP20

Please confirm the specification before install

User Manual (EPever_Tracer-AN_50-100A__User_Manual.pdf, 1,189 Kb) [Download]

Brand information
Brand :
EPever
Battery Information for inverters and controllers
Lithium Battery Activation :
  • Active Lithium Batteries
Battery Voltage :
  • 12V
  • 24V
Battery Type :
  • Lifepo4 Batteries
  • Lithium Batteries
  • Flooded Batteries
  • Gel Batteries
  • Lead-acid Batteries
  • AGM Batteries
  • User Mode
Solar Charge Controllers Features
Charging Current:
  • 50 Amps
Ground Type:
  • Netagive Ground
Solar Panel Max Input Power:
  • 1040W-2500W
Solar Panel Max Input Voltage:
  • 150V
Waterproof:
No
Other Information
Warehouse:
  • GER Warehouse
  • USA Warehouse
Find similar


5 out of 5
Reviews: 10
5 stars
100%
4 stars
0%
3 stars
0%
2 stars
0%
1 star
0%
MTBioGuy
Verified purchase
United States
Advantages
This 50amp model is just what I needed! Great PowMr support too!
Comment
This new 50 amp Tracer 5415AN controller is a replacement for my existing 30 amp Epever controller. I loved my 30 mp model but it was time to increase the number of batteries and PV panels in my system and I wanted a unit with plenty of potential expansion ability. This 5415AN has proven itself to be just what I needed!It's quite a bit larger than my 30 amp unit with lots of massive cooling fins in back. What I really like is that it will now allow my to direct connect up to 6AWG cabling from my battery and PV banks. Big improvement in cable size over my 30 amp unit!I also love the MT-50 remote readout. My inverter, controller, battery monitor, fuses and other electronics are hidden away out of the main living area of my travel trailer and yet with the MT-50 I can still have the ability to monitor my system as well as make programming changes right from my couch.I've also had several reasons to contact the Y-Solar tech support folks... no nothing wrong... just me asking for more pre-purchase info... and they were very responsive and helpful. Yes, I'd buy an Epever charge controller again!
Cecilio Padilla
Verified purchase
United States
Advantages
Works faster than my old charge controleri recommend
Comment
Was easy to install and to set up
Gregory R.
Verified purchase
United States
Advantages
Flawless so far.
Comment
So far so good. Pulling current from 6 100w panels in my 12v system.
Peter240
Verified purchase
United States
Advantages
Like it
Comment
Work great so far 25 month now.
M N M
Verified purchase
United States
Advantages
works as it should but old technology and programming could be improved
Comment
works as it should but old technology and programming could be improved! instructions are poorly written and user interface when trying to do a user defined setting was cumbersome and would have been much better if the instructions were more detailed about what each setting does. for example, when setting amp hr of battery bank, it should say for example, that the higher you set the ah bank setting, the higher amps it will push into the battery (if that is actually what its doing). I assume that most batteries are capable of charging at 10% of their ah rating so if a set of trojans 6v in series are 235ah then a 40 amp controller might only let 23.5 amps total pass through (I may have 500 watts of solar and perfect sun and wonder why i'm not getting 400+ watts and only seeing 317.25 watts (23.5 amps x 13.5 volts = 317.25) which is all the controller allows through even though the rest of the system is capable of 450+ watts. So telling us what each setting will do will let us realize that the controller is doing its job right and not defective and it is our battery bank that needs upgrading. also it might let someone know how important it is to put the right amp hr in setting...ive had many customers have no idea how to figure out the amp hrs of a bank of 6 trojan 6 volts that each battery is labled 235 amp hr so they multiply that by 4 to get 940ah when its actually 470 ah since they are series parallel to 12 volt...so they overcharge their new batteries. there are just so many things like this that could be included to make a customers project work properly and not blame it on the product. when my customers batteries get ruined or they don't see the wattage they expect then they automatically think the product doesn't work right. The "best reviewed" controllers out there like Victron, have great instructions, tech support and websites/videos that show the customer how and why each setting needs to be the way it is. Also, many of us use an AGM battery as a cheap battery that doesn't gas much but your settings only say flooded sla gel...no one knows that gel and AGM are same settings and that agm cant be equalized so its important to get the settings right. also give some suggestions like "to charge slower and increase the life of the battery bank, set it at 20% less amp hours or to charge faster and run loads during the day, set it 20% higher but watch for boilover of electrolyte...etc. these little devices are doing a lot of things so giving us more info about what its doing based on each setting would make a much better result in the long run. why is the programming so limited without the mt50? I cant even set battery bank size on the chassis display! some customers don't want the mt50 and cant load the software on to their computers because that is so old it doesn't work right on newer computers. all in all, these devices do their job pretty well but its the manufacturer who just does the bare minimum to make an average product when it could be exceptional!
Customer
Verified purchase
United States
Advantages
Good value and user friendly.
Comment
Bought this to manager 610 watts solar on the roof. Just got it hooked up two days ago and all seems to be working well. Digital is easy to real which is greatly appreciated. This unit is programmable which is a plus.
Lawrence Orsini
Verified purchase
United States
Advantages
Excellent.
Comment
This thing works well. I've tried more than a few MPPT and this is just solid.
Nelson
Verified purchase
United States
Advantages
A great solar controller
Comment
A great controller. This if my 4th. They work as promised with no problem like I have had with others
andy
Verified purchase
United States
Advantages
Doing what it says it does
Comment
Good
E***s
Verified purchase
Brazil
Comment
Very good product

You May Also Like
  • Bestsellers
  • Most Popular
Bestsellers
Fast and high quality delivery

Our company makes delivery all over the world

Quality assurance and service

We only offer quality goods with higher cost performance

Returns within 30 days

You have 30 days to test your purchase