EPEVER All In One Solar Inverter Charger 3000W DC 24V AC 220V UP3000-HM10022
UPower-Hi series is an all in one inverter charger that supports diversified energy management modes on solar/utility/generator charging, and utility/inverter power supply to the AC loads. To maximize solar energy utilization, users can choose energy sources according to actual needs and flexibly take the utility as a supplement. This all in one inverter charger can raise the system's power supply guarantee rate, which is suitable for solar energy, utility/oil generator hybrid systems. It aims to provide users with high-quality, high-stability, and high-reliability electrical energy.
- Supports the battery mode or non-battery mode.
- Non-battery mode: charging with solar (Main) and utility (Assist) simultaneously.
- Surge and reverse connection protections to support the lithium battery system perfectly.
- Three charging modes: Solar only, Solar priority, Utility & Solar.
- Two AC output modes: Utility priority and Inverter priority.
- High tracking efficiency of MPPT no less than 99.5%.
- PFC technology achieves a high power factor of AC to DC charging and reduces grid capacity usage.
- Advanced SPWM technology and pure sine wave output.
- Customized charging current and discharging limited current.
- SOC with the self-learning feature is visible on LCD.
- 4.2 inch LCD to monitor and modify system parameters.
- Optional WiFi or GPRS Remote control by the RS485 isolated communication port.
- Optional BMS-Link port, which takes the charging and discharging control from BMS.
|Rated battery voltage||24VDC||48VDC|
|Battery input voltage||21.6～32VDC||43.2~64VDC|
|Max. battery charging current||100A||80A|
|Continuous output power||3000W@30℃||5000W@30℃|
|Max. surge power||6000W||8000W|
|Output voltage range||220VAC(-6%～+3%)，230VAC(-10%～+3%)|
|Output wave||Pure Sine Wave|
|Load power factor||0.2-1(VA ≤ continuous output power)|
|Distortion THD||THD≤3%(Resistive load)|
|80% rated output efficiency||92%|
|Max. Rated output efficiency||91%|
|Max. output efficiency||93%|
|Switch time||10ms(Switch from the utility output to the inverter output) 15ms(Switch from the inverter output to the utility output)|
|Utility input voltage||176VAC～264VAC(Default) 90VAC～280VAC(Programmable)|
|Utility input frequency||40～65Hz|
|Max. utility charge current||80A||60A|
|Max. PV open circuit voltage||450V(At minimum temperature) 395V(25℃)||500V(At minimum temperature) 440V(25℃)|
|MPPT voltage range||80～350V||120~400V|
|Max. PV input power||4000W|
|(Note： For the curve of Max. PV input power Vs. PV open-circuit voltage, see chapter 3.4 Operating mode for details.)|
|Max. PV charging power||2875W||4000W|
|Max. PV charging current||100A||80A|
|Equalize charging voltage||29.2V(AGM default)||58.4V(AGM default)|
|Boost charging voltage||28.8V(AGM default)||57.6V(AGM default)|
|Float charging voltage||27.6V(AGM default)||55.2V(AGM default)|
|Low voltage disconnect voltage||21.6V(AGM default)||43.2V(AGM default)|
|Temp. compensate coefficient||-3mV/℃/2V(Default)|
|Zero load consumption||<1.8A||<1.2A|
|(without PV and utility connection, turn on the load output)|
|(without PV and utility connection, turn off the load output)|
|Dimension(H x W x D)||642.5x381.6x149mm|
|Mounting hole size||Φ10mm|
|Relative humidity||< 95% (N.C.)|
|Working temperature||-20℃～50℃(When the working temperature reaches 30℃ or above, the|
|load power is reduced appropriately; full load working is not supported«)|
|Altitude||＜5000m(If the altitude is more than 1000 meters, the rated power is reduced according to GB7260.)|
- No Lithium Batteries Activation
- Lifepo4 Batteries
- Lithium Batteries
- Flooded Batteries
- Gel Batteries
- AGM Batteries
- User Mode
- High frequency Inverters
- Single Phase
- build-in MPPT Solar Charge Controller
- 80 Amps
- Wifi Module(Optional)