PowMr 10A PWM Solar Charge Controller 12 Light Controller IP65 Waterproof
1. INPUT VOLTAGE BETWEEN 15V AND 41V - The 10A solar controller waterproof(IP68) is suitable for Outdoor Use. Intelligent 4-stage PWM charging. The PV can convert light energy into electric energy stored in batteries which will be protected by the solar controller.
2. Maximum power of PV is 120W for the 12Vdc system and 240W for the 24Vdc system, and the maximum current is 10A. It is suitable for 12Vdc/24Vdc rechargeable batteries. In order to lengthen its service life, please do not overload.
3. EASY TO MONITOR THE LED INDICATOR LIGHTS - The Solar Charge Controller integrates Three LED indicator lights: green (Charge indicator), White (BAT power indicator), and Red (Output indicator). The product also provides short-circuit, open-circuit, overload protection, as well as Dual MOSFET Reverse current and low heat protection
4. PWM SOLAR CHARGE CONTROLLERS - Working mode is 24 hours. Easy to mount directly to the frame of PV, the almost fuselage is surrounded by aluminum with a heat sink to dissipate heat.
A) Make sure your BAT has enough voltage for the waterproof solar charge controller to recognize the batteries type before the first installation and only sufficient voltage can charge or activate the controller. That means it won't charge or activate when hooked to a dead or low-voltage BAT or connecting only with PV but without BAT
B) The connection cable should be as short as possible to minimize loss.
C) The solar regulator is suitable for lead-acid batteries: OPEN, AGM, GEL It is not suited for nickel-metal hydride, lithium ions
D) The charge regulator is only suitable for regulating PV. Never connect another charging source to the charge regulator.
How to connect the solar system with the controller:
Step 1: Connect the BAT to the solar charge controller firstly- plus and minus. (it will auto adapts to the BAT voltage)
Step 2: Connect the load to the controller secondly.
Step 3: Connect the PV to the controller finally - plus and minus.
Note: The reverse order applies when de-installing.
4-stage PWM Charging
short-circuit, open-circuit, overload protection, as well as Dual MOSFET Reverse current and low heat protection
Any combination of solar module and battery, without causing damage to any component
Waterproof charge controller more suited for Outdoor Use. Such as light etc.
LED Indicator Lights
Three LED indicator lights:
It's helpful for finding out which part is wrong quickly.
◆ Color: Black
◆ Rated Charging Current:10A
◆ Rated Discharging Current:10A
◆ Max Solar Input Voltage: ＜41V
◆ System Voltage:12V/24V Auto Adapt
◆ Self consume: ＜10mA
◆ Operating Temperature: -20 ~ +60℃ ◆ Equalize Charging Voltage:14.4V/28.8V
◆ Bulk Charging Voltage:14.2V/28.4V
◆ Float Charging:13.8V/27.6V
◆ Discharge Stop Voltage:11.2V/22.4V
◆ Discharge Reconnect Voltage:12.6V/25.2V
◆ Housing: Aluminum Alloy
◆ Maximum Wire Size:16AWG
◆ Size/Weight: 3.23* 2.94* 0.83in/0.27lb
● 1 X 10A Waterproof Solar Charge Controller
● 1 X English User Manual
Please read the specification carefully before install
- No Lithium Batteries Activation
- Lifepo4 Batteries
- Flooded Batteries
- Gel Batteries
- Lead-acid Batteries
- AGM Batteries
- 10 Amps
- Positive Ground
- USA Warehouse
No reviews found