EPever 30A Dual Battery MPPT Solar Charge Controller 30 amp 12V 24V Auto DR3210N-DDS

In stock
BrandEPever Lithium Battery Activation No Lithium Batteries Activation Battery Voltage12V, 24V Battery TypeLifepo4 Batteries, Lithium Batteries, Flooded Batteries, Gel Batteries, Lead-acid Batteries, AGM Batteries, User Mode Charging Current30 Amps Ground TypeNetagive Ground Solar Panel Max Input Power500W-1000W Solar Panel Max Input Voltage100V WarehouseUSA Warehouse, GER Warehouse
$13999
+
Why PowMr?
  • — Fast Delivery
  • — 24 months warranty 
  • — Avg. response time 1 Hrs. (Working  Day)
  • PowMr Everywhere 
    Wholesale
    epever

    EPEVER DuoRacer MPPT Dual Battery Solar Charge Controller 30 amp 12V 24V Auto, Negative Ground Solar Controller for RVs Campers Caravan Boats Trailer

    mppt charge controller 30 amp 12V

    Overview:

    DuoRacer MPPT charge controller is made for charging two batteries (shown as BATT1 and BATT2 below) at the same time in a solar system. This controller supports multiple life battery (BATT1) types, including Sealed, Gel, Flooded, LiFePO4, and Li-NiCoMn, which is suitable for RV, Camper, Boat, and so on. The device recognizes the start battery (BATT2) system voltage automatically, and trickle charges the battery when the conditions are satisfied.
    The controller adopts the advanced MPPT Solar Charge Controller algorithm, which will minimize the maximum power point loss rate and loss time, also fast-track the maximum power point(MPP) of the PV array, and obtain the maximum energy from the solar array under any conditions. The energy utilization in the MPPT solar system is increased by 20-30% compared with the PWM charging method.
    When there is no manual operation for a long time, and the charging conditions cannot be reached, the controller will turn to low-power mode, which reduces the loss and battery power waste to enhance the products life. The system parameters are shown and set by LED/LCD or the MT11 remote meter (Accessory).
    The AES control signal of the car refrigerator is built into the controller, which will supply the surplus solar power to the refrigerator to avoid energy waste. The controller comes with an IP33 protection level, which is waterproof and dustproof. Multiple protection features, including battery overcharge protection, over-discharge protection, and reverse connection protection of the PV and battery, effectively ensure the solar system's safety, stability, and lifetime.

    30A mppt太阳能充电控制器12V

    Features:

    • Maximum Power Point Tracking technology with ultra-fast tracking speed and tracking efficiency is no less than 99.5% guaranteed.
    • Advanced MPPT control
    • l algorithm to minimize the MPPlost rate and lost time
    • The wider range of the MPP operation voltage to improve the PV module utilization
    • The auto-control function of charging power & charging current limitation(BATT1)
    • High quality and low failure rate components of ST, TI, and Infineon to ensure the product life
    • Digital circuit control of adaptive three-stage charging mode to enhance BATT1 life.
    • BATT1 type can be set via LED/LCD.
    • The product runs into the low-power mode when there is no manual operation for a long time, and charging conditions are not satisfied (PV<5V).
    • 100% charging and discharging in operation environmental temperature range.
    • LED and LCD display units are selectable.
    • AES control signal for car refrigerators to avoid energy waste.
    • Standard Modbus protocol, and RS485 (5V/200mA) communication port for the customer to expand the application area.
    • ①Life battery (BATT1) is the energy storage battery for powering the household loads in the off-grid system, which supports Sealed, Gel, Flooded, LiFePO4, and Li-NiCoMn batteries (the controller can NOT recognize the system voltage automatically).
    • ②Start battery (BATT2) is the energy storage battery that is usually built in the vehicle for powering the system such as RV and Boat, and only supports lead-acid battery (the controller will recognize the system voltage automatically).
    NOTE: the BATT1 and BATT2 must be at the same voltage level.

    Technical specifications:

    未标题-1未标题-2

    Negative Ground EPEVER MPPT Charge Controller

    • System voltage: 12V /24VDC Auto
    • Rated charge/discharge current: 30A
    • Max Input Power: 390WO(12V) / 780W (24V)
    • Max. PV Open Circuit voltage: 100V
    • Battery type: LiFePO4, Li-NiCoMn, Sealed, Gel, Flooded, User

    12V mppt solar charge controller 30 amp

    LCD Display

    • PV ( Voltage, Current, Kwh ), One key to zero clearing PV energy function.
    • BAT (Voltage, Current, Temperature ), Temp. compensation:-3mV/℃/2V(77℉) (default)
    12V mppt charge controller lithium

    COMMON NEGATIVE

    Ensure compatibility with any negative ground system, which is the standard and most conventional way of grounding

    epever mppt solar charge controller 30a 12V

    • Terminal: 6AWG /16mm2 (BATT1), 12AWG / 4mm2 (BATT2), Recommended cable size: 8AWG/6mm2 (BATT1),12AWG/4mm2(BATT2)
    • The red wire connects “+” and the Black wire connects “-”, Ensure tighten wires
    • Dimensions: 9.73 X 6.5 X 2.7 in / Weight: 3.85lb
    • ASIN: B085H9W3FF Package including 1X 30A MPPT Dual Battery Charge Controller • 1XRemote Meter MT11 • 1X Temperature Sensor • 1X English Manual
    • ASIN: B08534T16Q Package including 1X 30A MPPT Dual Battery Charge Controller • 1X Temperature Sensor • 1X English Manual
    30 amp mppt solar charge controller 12V

    Electronic Protect Functions:

    • PV reverse polarity / PV short circuit / PV over current alarm protection
    • Battery overcharge /Battery over-discharge / Battery reverse polarity protection
    • Load short circuit / Load overload protection / Overheating protection

    Package includes:

    1x MPPT 30A controller

    1x User manual

    type  POW-30AH-12.8V POW-50AH-12.8V POW-100AH-12.8V
    Nominal voltage 12.8V 12.8V 12.8v
    Rated capacity 30Ah(0.2C/25)℃(Min:29Ah) 50Ah(0.2C/25)℃(Min:49Ah) 100Ah (0.2C/25°C) (Min:96Ah)
    Operating voltage range 10V-14.6V(Typical:12.8V) 10V-14.6V(Typical:12.8V) 10V~14.6V (Typical:12.8V)
    Charging voltage 14.6V 14.6V 14.6v
    Dischange cut -off voltage  10V 10V 10v
    Charging current(Max) 15A  25A  50A
    Dischange current (Max) 30A 50A 100A
    Length 195mm 228mm 325mm
    Width 133mm 138mm 170mm
    Height 171mm 210mm 215mm
    Weight about 4.5kg about 6.2kg About 11.5kg
    Shell Plastics/Black Plastics/Black Plastics/Black
    Series Maximum support for 4 sets in series Maximum support for 4 sets in series Maximum support for 4 sets in series
    Parallel support support Support
    Alarm&potection Over Voltage ,Under Voltage ,Over Current,Short Circuit,etc Over Voltage ,Under Voltage ,Over Current,Short Circuit,etc Over Voltage, Under Voltage, Over Current, Short Circuit etc.
    Cooling mode  Automatic cold and hot  Automatic cold and hot  Automatic cold and hot
    Terminal stud M6 M8 M8
    Altitude ≤4000m ≤4000m <4000m
    Recommended operating charge temperature  15℃-40℃ 15℃-40℃ 15%~85%
    Recommended operating dischage temperature 15℃-40℃ 15℃-40℃ 0°C~50°C
    Recommended operating storagetemperature -20℃-45℃ -20℃-45℃ -10°C~60°C
    Humidity 15%-85% 15%-85% 15°C~40°C
    Operating Charge temperature 0℃-50℃ 0℃-50℃ 15°C~40°C
    -10Operating Dischage temperature -10℃-60℃ -10℃-60℃  -20°C~45°C
    Brand information
    Brand :
    EPever
    Battery Information for inverters and controllers
    Lithium Battery Activation :
    • No Lithium Batteries Activation
    Battery Voltage :
    • 12V
    • 24V
    Battery Type :
    • Lifepo4 Batteries
    • Lithium Batteries
    • Flooded Batteries
    • Gel Batteries
    • Lead-acid Batteries
    • AGM Batteries
    • User Mode
    Solar Charge Controllers Features
    Charging Current:
    • 30 Amps
    Ground Type:
    • Netagive Ground
    Solar Panel Max Input Power:
    • 500W-1000W
    Solar Panel Max Input Voltage:
    • 100V
    Waterproof:
    No
    Other Information
    Warehouse:
    • GER Warehouse
    • USA Warehouse
    Find similar
    Question: Can this controller be used to charge 2 12v batteries which are wired together in series?
    Answer: Hi dear customer, this controller can work with 24v battery,2 12v batteries which are wired together in series is 24v, so it is workable.


    No reviews found

    You May Also Like
    • Cyber Week Deals
    • Bestsellers
    Cyber Week Deals
    Fast and high quality delivery

    Our company makes delivery all over the world

    Quality assurance and service

    We only offer quality goods with higher cost performance

    Returns within 30 days

    You have 30 days to test your purchase