EPever 30A Dual Battery MPPT Solar Charge Controller DR3210N-DDS

Write a review
Ask a question
In stock
BrandEPever Lithium Battery Activation No Lithium Batteries Activation Battery Voltage12V, 24V Battery TypeLifepo4 Batteries, Lithium Batteries, Flooded Batteries, Gel Batteries, Lead-acid Batteries, AGM Batteries, User Mode Solar Panel Max Input Voltage100V Solar Panel Max Input Power500W-1000W Ground TypeNetagive Ground Charging Current30 Amps WarehouseUSA Warehouse, GER Warehouse

Minimum quantity for "EPever 30A Dual Battery MPPT Solar Charge Controller DR3210N-DDS" is 1.

Why PowMr?
  • — 24 months warranty
  • — Fast Delivery
  • — 8 hours service 
  • PowMr Everywhere 



DuoRacer MPPT charge controller is made for charging two batteries (shown as BATT1 and BATT2 below) at the same time
in a solar system. This controller supports multiple life battery (BATT1) types, including Sealed, Gel, Flooded, LiFePO4, and
Li-NiCoMn, which is suitable for RV, Camper, Boat, and so on. The device recognizes the start battery (BATT2) system voltage automatically, and trickle charges the battery when the conditions are satisfied.
The controller adopts the advanced MPPT control algorithm,which will minimize the maximum power point loss rate and loss
time,also fast track the maximum power point(MPP) of the PV array, and obtain the maximum energy from solar array under
any conditions. The energy utilization in the MPPT solar system is increased by 20-30% compared with PWM charging method.
When there is no manual operation for a long time, and the charging conditions cannot be reached, the controller will turn to
low-power mode, which reduces the loss and battery power waste to enhance the products life. The system parameters are
shown and set by LED/LCD or the MT11 remote meter (Accessory).
The AES control signal of the car refrigerator is built in the controller, which will supply the surplus solar power to the refrigerator to avoid energy waste. The controller comes with IP33 protection level, which is waterproof and dustproof. Multiple protection features, including battery overcharge protection, over discharge protection, and reverse connection protection of the PV and battery, which effectively ensure the solar system safety, stability, and lifetime.
Maximum Power Point Tracking technology with ultra-fast tracking speed and the tracking efficiency is no less than 99.5%
Advanced MPPT control algorithm to minimize the MPPlost rate and lost time
The wider range of the MPP operation voltage to improve the PV module utilization
Auto control function of charging power & charging current limitation(BATT1)
High quality and low failure rate components of ST, TI and Infineon to ensure the product life
Digital circuit control of adaptive three-stage charging mode to enhance BATT1 life.
BATT1 type can be set via LED/LCD.
Product runs into the low-power mode when there is no manual operation for a long time, and charging conditions are not
satisfied (PV<5V).
100% charging and discharging in operationenvironmental temperature range.
LED and LCD dispiay units selectable.
AES control signal for car refrigerator to avoid energy waste.
Standard Modbus protocol, and RS485 (5V/200mA) communication port for the customer to expand the application area.
①Life battery (BATT1) is the energy storage battery for powering the household loads in the off-grid system, which supports Sealed, Gel,
Flooded, LiFePO4, and Li-NiCoMn batteries (the controller can NOT recognize the system voltage automatically).
②Start battery (BATT2) is the energy storage battery which usually built in the vehicle for powering the system such as RV and Boat, and only
supports lead-acid battery (the controller will recognize the system voltage automatically).
NOTE: the BATT1 and BATT2 must be at the same voltage level.
Technical specifications:
Package include:
1x MPPT 30A controller

1x User manual

Please read the specification carefully before install

Brand information
Brand :
Battery Information for inverters and controllers
Lithium Battery Activation :
  • No Lithium Batteries Activation
Battery Voltage :
  • 12V
  • 24V
Battery Type :
  • Lifepo4 Batteries
  • Lithium Batteries
  • Flooded Batteries
  • Gel Batteries
  • Lead-acid Batteries
  • AGM Batteries
  • User Mode
Solar Charge Controllers Features
Charging Current:
  • 30 Amps
Ground Type:
  • Netagive Ground
Solar Panel Max Input Power:
  • 500W-1000W
Solar Panel Max Input Voltage:
  • 100V
Other Information
  • GER Warehouse
  • USA Warehouse
Find similar

5 out of 5
Reviews: 3
5 stars
4 stars
3 stars
2 stars
1 star
Verified purchase
United States
It works.
Brandon Robertson
Verified purchase
United States
I like how the LCD screen shows you the conversion right on the unit and it turns the extra voltage in to amperage for the batteries. Easy to Use and easy to connect.
Verified purchase
United States
I still like the unit

You May Also Like
  • Bestsellers
  • Most Popular
Fast and high quality delivery

Our company makes delivery all over the world

Quality assurance and service

We only offer quality goods with higher cost performance

Returns within 30 days

You have 30 days to test your purchase