PowMr Epever MPPT 10A Dual Battery Solar Controller DC 12V/24V PV 60V Auto Work For RV Camper Boat UK

You save: $10.00
In stock
Price in points: 98 points

Minimum quantity for "PowMr Epever MPPT 10A Dual Battery Solar Controller DC 12V/24V PV 60V Auto Work For RV Camper Boat UK" is 1.

Payment options
Our advantages
  • — 12 months warranty
  • — SMS notification
  • — Return and exchange
  • — Different payment methods
  • — Best price

PowMr UK warehouse,AUS warehouse,USA warehouse,GER warehouse and China warehouse

PowMr Epever MPPT 10A Dual Battery Solar Controller DC 12V/24V PV 60V Auto Work For RV Camper Boat UK


DuoRacer MPPT charge controller is made for charging two batteries (shown as BATT1 and BATT2 below) at the same time
in a solar system. This controller supports multiple life battery (BATT1) types, including Sealed, Gel, Flooded, LiFePO4, and
Li-NiCoMn, which is suitable for RV, Camper, and so on. The device recognizes the start battery (BATT2) system voltage automatically, and trickle charges the battery when the conditions are satisfied.
The controller adopts the advanced MPPT control algorithm,which will minimize the maximum power point loss rate and loss
time,also fast track the maximum power point(MPP) of the PV array, and obtain the maximum energy from solar array under
any conditions. The energy utilization in the MPPT solar system is increased by 20-30% compared with PWM charging method.
When there is no manual operation for a long time, and the charging conditions cannot be reached, the controller will turn to
low-power mode, which reduces the loss and battery power waste to enhance the products life. The system parameters are
shown and set by LED/LCD or the MT11 remote meter (Accessory).
The AES control signal of the car refrigerator is built in the controller, which will supply the surplus solar power to the refrigerator to avoid energy waste. The controller comes with IP33 protection level, which is waterproof and dustproof. Multiple protection features, including battery overcharge protection, over discharge protection, and reverse connection protection of the PV and battery, which effectively ensure the solar system safety, stability, and lifetime.
  • Brand: PowMr
  • Product Model: DR1206N-DDS
  • Maximum Power Point Tracking technology with ultra-fast tracking speed and the tracking efficiency is no less than 99.5% guaranteed
  • Advanced MPPT control algorithm to minimize the MPPlost rate and lost time
  • The wider range of the MPPT operation voltage to improve the PV module utilization
  • Auto control function of charging power & charging current limitation(BATT1)
  • High quality and low failure rate components of ST, TI and Infineon to ensure the product life
  • Digital circuit control of adaptive three-stage charging mode to enhance BATT1 life
  • BATT1 type can be set via LED/LCD
  • Product runs into the low-power mode when there is no manual operation for a long time, and charging conditions are not satisfied (PV<5V)
  • 100% charging and discharging in operationenvironmental temperature range
  • LED and LCD dispiay units selectable
  • AES control signal for car refrigerator to avoid energy waste
  • Standard Modbus protocol, and RS485 (5V/200mA) communication port for the customer to expand the application area
①Life battery (BATT1) is the energy storage battery for powering the household loads in the off-grid system, which supports Sealed, Gel,
Flooded, LiFePO4, and Li-NiCoMn batteries (the controller can NOT recognize the system voltage automatically).
②Start battery (BATT2) is the energy storage battery which usually built in the vehicle for powering the system such as RV and Boat, and only supports lead-acid battery (the controller will recognize the system voltage automatically).


Parameter Tables

  1. Warning:When the lithium battery of 12V is used and the BMS is protected, the lithium battery voltage may increase up to 35V which may damage the load, so please consider the load’s voltage
  2. At minimum operating environment temperature
  3. At 25℃ environment temperature
  4. The Temperature compensate coefficient is zero and not changeable when the life battery type is lithium battery
  5. AES port which output is 12V/200mA and RS485 Port which output is 5V/200mA are independent of DR1106/2106/3106N models, the AES port output voltage is the battery voltage. The above two ports of DR1206/2206/3206/2210/3210N models share the power of 5VDC/Max. 200mA
  6. The communication baud rate can only be set via PC software
  7. The LCD backing time can only be set via PC software, setting range is 0~999S and the 0s means the LCD is on all the time

Environmental Parameters

Mechanical Parameters

Correct Connecting Order : Battery - solar panel - load

Disconnect : solar panel - battery - load

User Manual (DuoRacer-SMS-EL-V1.0.pdf, 1,757 Kb) [Download]

Possibly you may be interested
  • Bestsellers
  • Most Popular
Fast and high quality delivery

Our company makes delivery all over the country

Quality assurance and service

We offer only those goods, in which quality we are sure

Returns within 30 days

You have 30 days to test your purchase