2000W Wind Power Grid Tie Inverter MPPT 3phase input 90V DC to output 230V AC Pure Sine Wave Grid Tie Inverter Wind SUN-2000G-WAL
Advantages:
- Advanced patented technology, MPPT efficiency is higher.
- High-quality imported components, more stable quality, lower failure rate. Significantly longer life, more than 10 years.
- Each inverter need to pass twice testing (20 hours) before leaving factory.
- Warranty: 2 years of free maintenance and replacement, lifetime technical support.
- Low cost and easy installation .
- Free combination.
- Combination of SGPV does not interact.
- Improving the efficiency of the entire solar power system.
- Low power consumption.
Feature:
- Low cost and easy installation
- Directly connect to three phase wind turbine
- Much better output waveform compare with similiar GTI
- Improving the efficiency of the entire solar power system
- Overload protection ,Anti-island protection
- Short-circuit protection/Reverse polarity protection
- AC output voltage and current THD<5%,PF>99%
Electronic protections:
- Overload protection
- Anti-island protection
- Short-circuit protection
- Reverse polarity protection
Package Including:
- Wind Inverter (with User Manual)---1pcs;
- Dump Load Resistor (basic accessory)---1pcs;
- AC Output Cable with Plug (Basic accessory)---1pcs;
- Inter Limiter Sensor (according to order)
- Wifi Plug II Generation (according to order)
Please confirm the specification before install
System diagram
Fig 1. structure diaram of AC grid connected with power generation system.
Fig 2. WAL model of SUN series grid tie invereter connected with AC output type of wind turbine.
Fig 3. Connecting two SUN-1000G2-WAL with a max. power is 2KW wind turbine.
Fig.4 Three Phases Grid Tie Power System
Tips
1.How to select a wind grid tie inverter ?
(1) Max output power of the wind turbine:
500w-1000w wind turbines , suggest 1000w inverter .
1000w-2000w wind turbines , suggest 2000w turbine .
(2)Voltage range :
24v 36v 48v wind turbines , suggest 22-65v inverter.
48v 60v 72v 90V wind turbines ,suggest 45-90v inverter .
Some wind turbines has been built-in a regulator , the output is DC , please choose DC input type wind inverter .
2.How to use a grid tie inverter with battery and wind turbine ?
If the user want to use a wind turbine to charge battery first , and output excess power to the grid , we suggest the battery function grid tie inverter(solar power GTI ,battery function ) . the wind inverter can not work with battery well .
3.What is the dump load controller/resistor ?
The dump load controller/resistor is used to protect the wind turbine and inverter .if the wind speed is too fast , the voltage will be high , it will work to reduce the wind turbines runing speed and voltage .
Similar products
At the same price!
PowMr Catalogue 2021
